If the dosage of water-reducing agent increases and the water consumption remains the same, the fluidity may exceed the expected range and the workability of concrete deteriorates. In the case that the concrete itself is in bad condition, it may lead to the increase of bleeding, which has a negative impact on the pumping construction. In addition, the increase of bleeding water may lead to the decrease of the surface strength and appearance quality of concrete.
If the water-reducing agent is over-doped, but the water consumption is reduced accordingly, and the workability of concrete is good, then the strength of concrete will increase correspondingly due to the decrease of water-binder ratio in this case, and there is no adverse effect on other properties.
For the water-reducing agent with retarding effect, overmixing may prolong the setting time, and the early strength of concrete is lower than that of concrete with normal dosage. Generally, the concrete is set within 48 hours, which usually has no adverse effect on the strength in the later period.
However, it is required to strengthen the early curing of concrete, so as to avoid excessive water loss of concrete in the plastic state on site, resulting in cracking of the concrete surface and affecting the strength and structural durability of concrete.
For the superplasticizer mixed with air entraining components, the gas content increases after overmixing, and the strength of concrete in the early and late stages may be reduced. Generally, the gas content below 4.5% has little effect on the strength of concrete, and the appropriate increase of gas content can play a positive and beneficial role in anti-freezing and anti-corrosive media. If the gas content exceeds 5%, the strength of concrete at all ages will be seriously reduced, which may cause quality accidents.
In general, the dosage of water reducing agent is less than 2 times of the normal dosage, the concrete is in good condition, the gas content is less than 4.5%, and the surface curing is properly strengthened after pouring, which will not cause adverse effects on the performance of concrete.






