Home > Knowledge > Content

Effects of overmixing of water reducing agents by several times on the properties of concrete

Aug 15, 2023

The first situation, in the ultra-high strength concrete, because the water-cement ratio ≤ 0.3 or even as low as 0.2, in this case usually shows that the state of concrete is not sensitive to the water reducing agent dosage, in order to achieve the ideal mobility state, the water reducing agent dosage is usually 5-8 times the normal dosage, i.e., the dosage of polycarboxylic acid needs to be 5% -8%. For concrete below C50, such a high dosage is incredible. However, the test results show that the strength of concrete at this dosage develops well at all ages, and it is equipped with concrete with 28d strength greater than 100MPa. The reason is: the dispersion of water reducing agent on cement is only physical adsorption, water reducing agent molecules adsorbed on the surface of cement particles, through the role of spatial site resistance and electrostatic repulsion, so that the flocculation structure of cement particles disintegrated, releasing the free water that is wrapped up, so as to make the concrete mobility increase, and the polycarboxylic acid system of water reducing agent, because of its special comb structure, it can be prevented from the coalescence of the cement particles again for a certain period of time, thus It has good slump retention performance. Once more than a certain period of time, the cement hydration products will be adsorbed on the surface of the cement particles of the water reducing agent molecules completely wrapped, water reducing agent molecules are shielded after the dispersion of the effect completely disappeared, and then no longer have any effect and influence on the concrete, the cement is normal hydration, the normal development of the strength of the concrete. Of course, because of the high water reducing agent dosage, the concentration of water reducing agent molecules in concrete is large, after some molecules are covered by the cement hydration products, there are new molecules adsorbed on the surface of the cement hydration products, preventing the cement particles from rapidly lapping to form a network, which to a certain extent, makes the setting time prolonged, but the general cement will not be set for more than 24h.

The second situation, the water reducing agent itself has a certain degree of air-entraining and retardation, then several times over-mixed may have a greater adverse effect on the performance of concrete. Generally speaking, the dosage of retarder component is based on the temperature environment, engineering requirements and water reducing agent normal mixing to determine, if the retarder component is over-mixed several times, due to a large number of retarder component adsorption on the surface of the cementitious material particles, affecting the normal hydration of the cementitious material, or to make the setting time significantly longer, or lead to the concrete for several days without condensation or permanent non-setting. Generally 2d or even more time to set the concrete, because the hydration process is too delayed, the type and quantity of hydration products change, resulting in a permanent reduction in concrete strength. Of course, for the subway bite pile (generally need 72-90h initial set) and pile foundation, bearing platform, dam and other large volume concrete construction, itself requires a long period of setting time, generally in the proportion design to appropriately increase the strength level, in order to ensure that the 28d strength to meet the design requirements.
 

Send Inquiry